Friday, September 26, 2008

Learn about Metal Casting Torches and Furnace Torches for Metal Casting

Metal Casting

When one talks about Oxy-Fuel Cutting or Oxy-Fuel Welding, they mean the process when you cut or weld metals by using pxygen and fuel gasses.Really, these two processes are very very different. In the first process, a cutting torch is made use of for heating ferrous metal to a temperature of around 980 degree Celsius. An oxygen stream is being trained on a hot metal that combines with iron chemically which later flows from the kerfs, or cut in the form of slag of iron oxide. In the second process, a ‘welding torch’ is made use of for welding metals.

Oxy-Fuel torches are not torches that take the air and use it to burn the inside fuel. They stand out owing to the use of single tank. Really, this happens because you need two tanks and oxygen and fuel for welding. It’s not possible to melt some of the metals with single-tank torches. Therefore, you can use these torches all you way for brazing and soldering but they should not be used for welding. A metal-cutting torch is better known as hot blue spanner, blue wrench, hot wrench, smoke wrench, and gas-axe.

Types of Metal Casting Torches: The torch can be defined as the part held and manipulated by the welder to get the weld made. It possesses a valve and connection for oxygen and the same things for fuel gas, a handle to obtain the grip, an integrating chamber (angularly set) where there occurs a mixing of oxygen and fuel gas, with a tip where formation of flame takes place. The fuel gases used along with oxygen include propylene, propane, hydrogen gas, MAPP gas, Liquefied Petroleum Gas (LPG), and the most widely used is acetylene. 

Injector Metal Casting Torch: It can be defined as an archetypal oxy-fuel torch, also known as an equal-pressure torch. It carries out the mixing of mere two gases. The injector torch operates in such a way that high pressure oxygen comes out of the tiny nozzle present in the torch head, and the fuel gas gets dragged towards it via the venturi effect.

Rose-bud Torch: The use of this torch is to carry out the heating of metals for straightening, bending, etc. It is generally used where a huge area requires heating. It produces a rose-bud shaped flame at the end, hence the name. This torch can carry out the function of heating small areas like rusted bolts and nuts as well. However, here, filler rod won’t be used with torch.

Cutting Metal Casting Torch: The head of the cutting torch is used for cutting metal. Its identification details are as follows: The inside of the torch consists of a combination of oxygen and acetylene. It helps in producing flame of a high temperature. Its 90 degrees where the three pipes are attached to the nozzle. It also contains an oxygen-blast trigger which blasts away the material during its cutting by the way of providing oxygen.

Welding Torch: The welding torch consists of either 1 or 2 pipes running towards the nozzle without oxygen-blast trigger. As the name suggests, it performs the function of welding.


A new Community site called Metal Casting Zone is where you can come to learn everything about Metal Casting and Share your Secrets with Other Members. Come by today and join the site for free and you get a free Metal Casting Basics EBook just for signing up! Stop by the website MetalCastingZone.Com right now to get your Free Ebook that is all about Metal Casting and Metal Casting Basics for Free.

No comments: