Some of the Metal Casting supplies are described below.
Cast cutters and blades: There are two varieties of cast cutter blade for plaster casts – 2 inches and 2.5 inches. This comprises of one blade and in most of the cutters, stainless steel blades fit in. This has a maintenance free operation and is comfortable to use. There is a high torque motor and an ON / OFF switch. The Cast cutter blade for synthetic casts is also available in two sizes – 2 inches and 2.5 inches. This has the same features as mentioned above. The Hercules Plaster Shears 7.5 inches is a Hercules heavy duty bandage and plaster shears 7.5 inches (19.1 cm) and has a serrated blade. The Cast cutter heavy duty with metal housing consists of one 2 inches fiberglass blade. In most of the cutters, a stainless steel blade can be fitted. The length is 12.5 inches and weight is 3 lbs 13 oz. This is specially lubricated for greater service and more comfort. The heavy duty can be used in both clinical use and fabrication setting.
Cast padding: The specialist Casting padding 3 inches X 4 yards is made up of micro pleated cotton fabric that stretches more than 50 percent. There is no need to tear and tuck for a smooth and comfortable fit. This is also available in sizes of 4 inches X 4 yards as well as 2 inches X 4 yards. The Sof Rol padding 3 inches X 4 yards is made of 100 percent surgical grade rayon. This is also available in sizes of 2 inches and 4 inches X 4 yards.
Metal Casting splinting materials: The orthoplast II splint material plain is available in size of 18 inches X 24 inches X 1/8 inch. The setting time is 3 to 4 minutes. The finished splints can be butt bonded, hinged, bonded, strapped and riveted. There is a wax coated surface. This is self adhering when heated. This is majorly designed for upper extremities. Hand Splints is where this really comes in handy. Its the contours of the body that is molds to so you don't get any wrinking which is very good. The orthoplast splinting material plain is available in sizes of 18 inches X 24 inches X 1/8 inch. This is made of a low heat thermo plastic material and is highly comfortable. After this material is heated, it can be molded or cut to any shape and adheres to itself. This material can be butt bonded, hinged, bonded, strapped and riveted. This can also be used in cylindrical casting procedures.
Heat gun: This is of two types – heat gun and master heat gun 220 volt.
Splinting pans: The forma splint 14 inches X 10 inches is an extremely compact and lightweight design. So, it is perfect for small splinting needs or for varying spots. This has a stainless steel working tank of dimensions 13 inches X 9.5 inches X 1.25 inches. This has a lexan cover. Its important to have a good working thermostat so it can maintain the water temperature between 150 and 190 degrees Farenheit. There is a high heat safety switch and grounded hospital grade plug. The empty weight of this device is 5.5 lbs. The Required Temperature is reached in only around 15 seconds.
Metal Casting ZOne is a new community website all about Home and DIY Metal Casting. Come by today and join the site for free and you get a free Metal Casting Basics EBook just for signing up! Come by MetalCastingZone.Com Today for your free Ebook on Metal Casting.
No comments:
Post a Comment